Technology of the paint work on painting works – quite complicated from a technical point of view of the process. For the best result it is necessary not only to have the necessary skill work, but also be fully 'Armed' – to have on hand all the necessary tools and support materials to seal cracks alabaster and correcting surface defects, the solution for repairing plaster, degreasers, masking tape to close the sites are not subject to stain, sealer, sealant gun, sponge rollers, brushes and much more. Any painting must be multilayered, each layer performs its function. The bottom layer is for better grip multi-layer coating to the substrate. Topcoat and final colored coating that protects the lower layers from external influences and performs a decorative function.
The number of layers depends on the type of paint required quality of surface and form the base. Quite important (if not most) stage of painting – surface preparation. A. F. Chief of Staff : the source for more info. The surface should be cleaned of dirt, rust, grease, and in addition, dried (this especially true for wood surfaces). If the pores of the wood remains water, the dye will not penetrate there. She will lie on the surface and then fall off. If the wood surface is dry, and moist inside, with heated in the sun and other influences water vapor pressure will be lower on the colorful cover and rip it. Exception – acrylic paint and impregnation, creating a 'breathable coating', which releases moisture inside, but does not let outside. The first layer of primer when painting always.
Using the technology, depending on the type of surface and type of paint products, used different primers. Concrete – acrylic, metal and wood – and GF nitrogrunty under decorative wood primers (Senezh, Tikkurila, Finncolor) – special antiseptic primers. At least – he paint the material with the addition of solvent (meaning the matter is diluted material as for the acrylic enamel, for example, the solvent is water) in an amount of 10-30% by weight of the material. The time between applying the first layer of soil and paint material should definitely observe (usually written on the packaging, if not – the Internet in your hands). At first, the paint is applied to the faces in the corners and inaccessible places and only later on smooth surfaces. Then carefully cover the entire surface of at least two coats of paint material, because only then we can assume that the surface is completely covered and protected. Time between coats depends on the type of material and is always written on the packaging. In carrying out house-painting thing the main thing – it's maintaining the technology. All that is written on a bank or instructions for use, says there is not just. Remember – the quality of painting is always guaranteed by the manufacturer of the material only if all technological standards. By following these simple rules, you can easily do the painting yourself and get a good result.