Technology Application

We recommend that you use to plaster the walls 'stucco'. To understand the benefits of using 'plaster', it should consider the following features: applied to the wall with a thin layer that allows you to display a wall with a minimum of material, does not shrink and does not crack, dry out in two times faster than conventional plaster putty consumption of plaster surface is greatly reduced. If take into account all these factors, the total cost of materials compared with similar work using conventional cement-sand mix will remain unchanged. However, you will significantly save on time, the cost of the work and certainly get better and more reliable result. Before applying the plaster, the wall is applied to the soil depth of penetration, which allows a layer of plaster is stronger hold on the wall. In plaster wall in a fiberglass reinforcing mesh, which allows you to smooth out the voltage inside the plaster and avoid the appearance of microcracks.

Next on the surface of the plaster is applied several coats of putty. Before each layer of the ground surface. Then the wall is polished and applied topcoat sealers (special putty with a small fraction). If the wall is being prepared for painting, polishing and then coating produced by the light special high-powered searchlights, which allows you to keep track of the smallest flaws on the wall. At the end of the pre-treatment of the wall is ready for application of finishing materials (paint, wallpaper, decorative plaster, etc.) Technology Application of different types of finishing materials are not identical. Next we take a closer look at some of them.

Paint the ceiling preparation does not differ much from the training walls. Device screed and waterproofing First, using gidrourovnya done marking of the floor level. Of the place, most raised relative to the rest room, then on the walls made a mark of zero.

Russian Floor

Before you buckle your hands is the surface of the concrete slab is cleaned of dust and dirt. Ideal to clean concrete impossible, so then primed surface binders. Primed surface provides good shvatyvaemost with screed. It is important for either sex, but especially for ceramic tile. If buckle under the tile poorly grasped with the cooking surface, then walking on a tile will be heard the characteristic sound of, and eventually the floor will be uneven and the tiles will start to detach from the base and “fly.” In Russia traditionally buckle made of dry concrete mixtures. Since the mixture of concrete and sand in any proportion – not a very durable material, then it is added adhesives. Before the screed will be laid floor covering, it must dry. An experienced master of the construction firm will always be able to pinpoint the degree of humidity tie, I will only note that the average time needed to dry – 45 days.

After this, the screed is applied waterproofing cover, and on top – moisture-resistant sheet of plywood, 12 mm thick. Plywood does not interfere, under any cover, but it is especially necessary for flooring, or high humidity (water leak or just a few days of early autumn, when is wet weather and central heating is not included) can destroy the most beautiful and expensive hardwood floor. In the European technology for the manufacture of cable ties are special self-leveling mix – so called self-leveling floors. Under these mixtures for additional noise and heat insulation are often put a layer of styrofoam, and for extra waterproofing on top plank polymer film. This floor dries much faster common ties (approximately 10-15 days).

Directly to the self-leveling floor can be laid tile, laminate and carpeting. To lay the same parquet necessarily need a layer of plywood. In addition, the bulk layer has a floor very small thickness (25 mm.), which is especially useful in homes with low ceilings.