We recommend that you use to plaster the walls 'stucco'. To understand the benefits of using 'plaster', it should consider the following features: applied to the wall with a thin layer that allows you to display a wall with a minimum of material, does not shrink and does not crack, dry out in two times faster than conventional plaster putty consumption of plaster surface is greatly reduced. If take into account all these factors, the total cost of materials compared with similar work using conventional cement-sand mix will remain unchanged. However, you will significantly save on time, the cost of the work and certainly get better and more reliable result. Before applying the plaster, the wall is applied to the soil depth of penetration, which allows a layer of plaster is stronger hold on the wall. In plaster wall in a fiberglass reinforcing mesh, which allows you to smooth out the voltage inside the plaster and avoid the appearance of microcracks.
Next on the surface of the plaster is applied several coats of putty. Before each layer of the ground surface. Then the wall is polished and applied topcoat sealers (special putty with a small fraction). If the wall is being prepared for painting, polishing and then coating produced by the light special high-powered searchlights, which allows you to keep track of the smallest flaws on the wall. At the end of the pre-treatment of the wall is ready for application of finishing materials (paint, wallpaper, decorative plaster, etc.) Technology Application of different types of finishing materials are not identical. Next we take a closer look at some of them.
Paint the ceiling preparation does not differ much from the training walls. Device screed and waterproofing First, using gidrourovnya done marking of the floor level. Of the place, most raised relative to the rest room, then on the walls made a mark of zero.