1. Spraying Spraying is used when painting large surfaces. When spraying paint 'Hemmerayt' should be to choose the correct viscosity. The instructions given by the ratio of paint and solvent 'Brush Cleaner & Thinners' 2:1. This relationship is true at t = 18-22 C at a temperature of above 23 C viscosity is better to choose for themselves (ie, considering the pressure on the spray of ink, and his skill). Typically, in this case, the solvent will have to add, otherwise it will be observed as pautinoobrazovanie substrate and the nozzle spray. At temperatures below 17 C may be a run-off paint from the surface, in this case it is necessary to reduce the amount of solvent ..
In the absence of the instrument to determine viscosity – the viscometer, the viscosity can be determined 'by eye' as follows: in a clean jar pour the appropriate amount of paint, add a little solvent, a wooden stirrer to mix the paint, with each new piece of solvent to lift the mixer over a jar to determine whether there is a gap of paint after 2-3 seconds swelling with a mixer. Paint 'Hammerite' is applied in 4 layers and give exposure between the layers for 20-30 minutes. For best results, need a second layer to cause a very, very thin, almost to deposition, stand 2-3 minutes and then apply subsequent coats. The last layer should be as thick, but just enough so that when there was no streaks and sag on the painted surface. (When working with hammer paint on it you should pay special attention).
2. Brushing. Suitable for small and flat surfaces for painting the iron fence of a complex configuration. It should be applied 2-3 coats. Must pay special attention to paint edges and corners, as there are corrosion begins in the first place. When working with complex and vertical surfaces is better to apply the paint in several thin layers (5 – 6).